Eos GNSS frequently asked questions FAQ

How do I insert the Skadi battery into the Skadi receiver or remove it?

To insert your Skadi battery pack

To insert the battery into the Skadi receiver, place the battery into the slot with the LED fuel gage facing outward. Push the battery pack until it clicks into place.

Hand holding Skadi unit and showing open battery compartment
The LEDs on the Skadi battery pack fuel gauge will blink while charging. Once the fuel gauge turns solid and stops blinking, the battery is fully charged (about two to four hours).

To remove the battery pack from your Skadi receiver:

To remove the battery from the Skadi receiver, squeeze the two release flaps on both sides of the receiver and pull the battery out.

Remove the battery from the Skadi receiver by pushing the two release flaps on the side of the receiver and pulling the battery out.
Remove the battery from the Skadi receiver by pushing the two release flaps on the side of the receiver and pulling the battery out.

Still Need Help? Contact Technical Support

If you are still unable to resolve your issue, reach out to our tech support team.

< Main FAQ Page